Mix&Match Holographic Pride/Pronouns Pins

from €7.00

Create your perfect Bun with these Mix&Match Holographic Acrylic Pins!

Choose between 6 different bunny designs and lots of different middle pieces including pronouns, many queer pride flags and other labels.

There are also two blank pins that you can write with dry erase markers on, in case you can't find your pronouns, want to use the pins as a nametag or want to write anything else on it. (Be sure to use NON permanent markers so you can erase the writing again! Pen is not included.)

For the Bunnies I have two sizes currently available, the big one is 5cm in width and the slightly smaller one 4.5cm; the size difference is not big and both fit the middle pieces perfectly.

DETAILS:

  • holographic acrylic pins

  • protective film on both sides!

  • dimensions: each about 5cm in width. Top bunny part about 4cm in height, bottom bunny part and middle parts about 2.5 cm in height (they are a bit CHONKY!)

  • each pin comes with a light or bright pink rubber clutch

To order please add every pin you want to your basket. The bunny pins includes both the top and bottom part.

Make sure to be gentle with the Pins to avoid them falling off! The metal pin is glued securely to the acrylic base but if they are handled very roughly and without care there is a chance they could fall off.

Pins:
Design:

Create your perfect Bun with these Mix&Match Holographic Acrylic Pins!

Choose between 6 different bunny designs and lots of different middle pieces including pronouns, many queer pride flags and other labels.

There are also two blank pins that you can write with dry erase markers on, in case you can't find your pronouns, want to use the pins as a nametag or want to write anything else on it. (Be sure to use NON permanent markers so you can erase the writing again! Pen is not included.)

For the Bunnies I have two sizes currently available, the big one is 5cm in width and the slightly smaller one 4.5cm; the size difference is not big and both fit the middle pieces perfectly.

DETAILS:

  • holographic acrylic pins

  • protective film on both sides!

  • dimensions: each about 5cm in width. Top bunny part about 4cm in height, bottom bunny part and middle parts about 2.5 cm in height (they are a bit CHONKY!)

  • each pin comes with a light or bright pink rubber clutch

To order please add every pin you want to your basket. The bunny pins includes both the top and bottom part.

Make sure to be gentle with the Pins to avoid them falling off! The metal pin is glued securely to the acrylic base but if they are handled very roughly and without care there is a chance they could fall off.